Solution for Replacement Foot Plate for Lippert Level Up System
Updated 09/25/2019 | Published 09/24/2019
Products Featured in This Question
Question:
Do you need to keep the cylinder from turning when installing this, if so how, what is the recommendation for torque?
asked by: Russell S
Expert Reply:
The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use # LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will thread onto the bottom of the jack leg in place of the 7/16 bolt that comes with # LC314667.
Since this uses a horizontal attachment hole you would not have to worry about the feet turning. You need to torque to 132 ft-lb.
Product Page this Question was Asked From
Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- Lippert
more information >
Continue Researching
- Search Results: lippert foot pad
- Search Results: snappad rv jack pads
- Search Results: snappad
- Shop: Replacement Front Foot Pad for Lippert Components Ground Control 3.0 Leveling System
- Shop: Replacement Pad for SnapPad Jack Stand Pad System - 9" Round Jack Foot
- Search Results: winnebago hydraulic leveling system parts
- Search Results: self contained hydraulic jack
- Q&A: Recommended Replacement for Atwood GCH6A-10E RV Water Heater
- Shop: Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube
- Shop: Replacement Pad for Stromberg Carlson RV Jack Pad System - 11-1/2" Round Jack Foot - Qty 1
- Search Results: lippert leveling system rv jack pads
- Video: All About the Dometic RV Water Heater
- Shop: Dometic RV Water Heater - 10,000 Btu - Propane/Electric - 6 Gallon Tank - 120V - No Door
- Search Results: leveling jacks
- Shop: Replacement Foot Plate for Lippert Power Gear Hydraulic Jack
- Shop: Replacement Rear Foot Pad for Lippert Components Ground Control 3.0 Leveling System
- Video: Review of the Replacement Foot Plate for Lippert Power Gear Hydraulic Jack
- Video: The Low-Down on the Loctite Threadlocker 262
- Q&A: Snap Pads Installation And Troubleshooting Questions
- Q&A: Replacing Foot Pad On Lippert 6-Point Level-Up System - 132 Ft-lb Torque Requirement + Loctite
- Video: Detailed Breakdown of the Replacement Rain Sensor for MaxxAir RV or Trailer Roof Vent Fans
- Video: Review of SnapPad RV Leveling Blocks - Red StakPad Universal Jack Pad RV Trailer - SN97VR
- Q&A: Amperage Draw of MaxxAir MaxxFan Trailer Roof Vent w/ 12V Fan - w/ Rain Cover # MA00-06200K
- Q&A: How to Disable Rain Sensor Feature on MaxxAir MaxxFan RV Vent MA00-04500K
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Article: Trailer Wiring Diagrams
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Video: Feature Review - Big Truck Big RV Trailer Jack Foot Scale with Tongue Weight Gauge
on Accessories and Parts
