Recommended Air Bags for a 1997 Winnebago Adventurer

Question

Question:

I have a winnebago 1997 adventurer on an F53 ford chassis... need to replace the rear airbags main axle Winnebago # is 090436-15-704 Tag axle # is 090436-42-716 can you cross this number and give me a up to date direct replacement. Please advise thanks

asked by: Craig G

0

Expert Reply:

I have a replacement option for you but we don't have a database for part numbers and when I searched those numbers online I didn't find any direct replacements. Instead I recommend the Air Lift LoadLifter 5000 Ultimate Air Helper Springs item # AL88208. These air springs have a 5,000 lbs capacity and are custom fit for your 1997 Winnebago Adventurer.

expert reply by: Jerred H

0

Answer 1

As Atwood is no longer produced, I was unable to find much of anything to do with the specifications, unfortunately. With that being said, the best option we will have will be the Ultra-Fab Deluxe Electric Landing Gear Set #UF17-943010. This will…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

A 5th wheel trailer hitch is not vehicle specific but the mounting brackets beneath the truck bed can be. For a 1993 Ford F-250 the correct kit is #RP30035. This same installation kit does fit the 1999 Ford F-250 short or long bed. I have included…

view full answer...

Answer 7

Hey Dave, the install harness part #3063-P does fit to the green connector that is under your seat in your 2025 Mercedes Benz Sprinter 4500 and would work great with the P3 part #90195 which is widely considered to be the best controller around. I…

view full answer...

Answer 8

The correct replacement airbag for your Air Lift LoadLifter 5000 part 5813 is the Replacement Air Spring for Air Lift LoadLifter 5000 part #AL50201.

view full answer...

Answer 9

Hey Jacob, the ApexAnchor tie downs part number #TL38SV and #TL26SV work perfectly fine with running boards so you would not need to remove them.

view full answer...

Answer 10

TorkLift doesn't have their instruction manuals posted online so I'm unable to find the exact step by step instructions, but I was able to find a video where Shane will walk you through installing a similar front mounted tie-down model to…

view full answer...

Answer 11

I attached a picture that shows the Torklift Camper Tie Down #TLF2021 installed on a truck with a set of running boards. If the running boards are cab length they'd be fine, but if they go from the wheel well to wheel well they would interfere as…

view full answer...

Answer 12

The Concertone Genesis GT-3.0 has the same double din mounting requirements which refers to the cutout dimensions needed for installation as the iRV RV Stereo part #IRV34. Therefore, the overall size of the unit may be smaller but this should not…

view full answer...

Recommended Air Bags for a 1997 Winnebago Adventurer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching