Will the AirBedz Rear Seat Air Mattress Fit Behind the Passenger/Driver Seats On A Ford Transit 350?

Question

Question:

We have a 2020 Ford Transit 350 high roof, passenger van. We are needing a mattress or pad for the FIRST row of seats directly behind the driver/passenger chairs , for a long trip and rest. Will this fit? What about leaks? Its going to be a 5 day drive, no time of ill fitting or leak issues.

asked by: Kathy T

0

Expert Reply:

I spoke with AirBedz and they are not going to be able to say yes or no the AirBedz Rear Seat Air Mattress w Portable 12V Pump # AB42ZR will fit where you're wanting to put it.

Instead, what is recommended is to measure the area you're wanting to use it and compare it to the measurements listed. When inflated, this mattress measures 55" long, 35-1/2" wide, and is 17-3/4" tall, so if the area you're looking can accommodate these measurements then you're good to go.

Also, this mattress has a maximum weight capacity of 800-lbs and takes approximately 2 minutes to fully inflate.

As far as leaking, there has not been an overwhelming report of leaking but there has been some reports of leaks, however there is an included patch kit to remedy that issue.

expert reply by: Bryce D

0

2020 Ford Transit 350
(click to enlarge)

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Hi Lizzy! The Blue Ox Trailer Hitch Receiver - Custom Fit - Class III - 2" #BLU46HR is just the hitch, but we definitely have wiring for your 2022 Jeep Grand Cherokee L. For that, you will want the Curt T-Connector Vehicle Wiring Harness with…

view full answer...

Answer 3

Yes, Josh - the TowSmart #TS34ZR is confirmed to fit your 2024 Subaru Outback Limited XT perfectly. It uses the factory frame attachment points, so there’s no drilling involved, just a little exhaust lowering and heat shield trimming per the…

view full answer...

Answer 4

That’s a fair question, Tom. The TowSmart #TS34ZR is a no-drill install, but you will need to trim the heat shield slightly around the forward mounting points to make room for the bolts. No cutting of the bumper or fascia is required. The process…

view full answer...

Answer 5

Hello Bryon, thanks for reaching out. We can definitely provide the 5th wheel rails and frame brackets for your 2024 Chevy 1500 long bed. Basically, all of the rail kits we offer are industry standard. For your truck I recommend the following: -…

view full answer...

Answer 6

Hello David, great question. So, there is a chance that you will have to enlarge the access holes for the both the etrailer #e98912 hitch and the EcoHitch #306-X7365. Both hitches come with the same size spacers. The picture below will help…

view full answer...

Answer 7

Twist link chains offer excellent traction in deep snow and some are even rated for mud. They provide decent traction on ice, and since they have rounded edges ride quality isn't too bad. V-Bar chains are similar but have better grip on ice. For…

view full answer...

Answer 8

Hey Marvin, welcome back. The only reason you would want to run individual air lines for the Air Lift 1000 Air Helper Springs item #AL62WQ is if you wanted to inflate the air bags with different pressure. Seeing as how all the weight of your camper…

view full answer...

Will the AirBedz Rear Seat Air Mattress Fit Behind the Passenger/Driver Seats On A Ford Transit 350?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching