Can I Connect to the B&W Continuum Weight Distribution System at an Angle?

Question

Question:

I have to back into my trailer at an angle to hook up. Can you hook up the Continuum from an angle? I have seen a couple of different videos and they always show them hooking up from a straight line. TIA

asked by: Peter

1

Helpful Expert Reply:

Yes, you can. Given the B&W Continuum Weight Distribution System item # BW28FR unique design you do not have to back straight up to the trailer to hook it up to your truck.

expert reply by: Jerred H

1

Answer 1

Good morning! To answer your first question, yes the B&W Continuum Weight Distribution System #BW28FR will work very nicely on your Grand Design 2970RL. You are well within the maximum weight parameter of 16,000 lbs, so it will work nicely to…

view full answer...

Answer 2

Since you are transporting a fifth-wheel trailer, I assume you are looking for rear-axle air bags. We only carry Firestone-brand Ride Rite air bags that will work with 4-wheel drive models of 2021 Ford F-350 Super Duties with an in-bed hitch. That is…

view full answer...

Answer 3

Since you are pulling a trailer that weighs around 8,500 lbs. you would just want to stick with the Firestone Ride-Rite Air Helper Springs #F35FV (5,000 lb.). You really only need to spend more for the Firestone Ride-Rite Red Label Extreme Duty Air…

view full answer...

Answer 4

Hello George, I definitely recommend going with the 2,800 lb Sumo Springs #SSR-127-54 for your 2023 Ford F-350. With your trailer being around 1,200 lbs of tongue weight we would be pushing the 1,500 lb springs pretty close to capacity and you may…

view full answer...

Answer 5

No. If you're 2019 Ford F-150 has built in electronic sway control then it does the same thing that the Curt True Course Advanced Bluetooth Trailer Sway Control item #C94VV does. You would have to disable the built in sway control to use it.

view full answer...

Answer 6

Out of the two Firestone kits that we offer I recommend The The Firestone Ride-Rite Air Helper Springs #F35FV because you're only towing a 10,000 pound trailer and your pin weight will be under 5,000 pounds which will provide you with a more…

view full answer...

Answer 7

Hello Dan, Definitely on the right road to a smoother ride (pun intended). I would say that you knowing you are on the heavier end of the tongue weight you are safe finding one around the 1k mark. You just want to make sure you are closer to the…

view full answer...

Answer 8

The Firestone Ride Rite part #F35FV is a confirmed fit for your 2020 Ford F-250 with the OEM in-bed fifth wheel rail kit. Then for a wireless compressor kit the Air Command Compressor System w/ Wireless Remote and Heavy Duty Compressor #F96VV is a…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Can I Connect to the B&W Continuum Weight Distribution System at an Angle?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching