Correct Replacement For Power Gear Slide Out Motor 522735s

Question

Question:

Hello I have an 2005 coachman santara class A motorhome. Im looking for a side out motor power gear # 522735s Thanks any info would be outstanding

asked by: Ron G

0

Expert Reply:

I verified with Lippert the correct replacement for your Power Gear slide-out motor 522735s is the following:

- Replacement Gear and Motor Assembly for RV Slide Out - High Torque - Driver Side # LC386735

expert reply by: Kyle S

0

Answer 1

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 2

I was able to cross reference the slide-out motor 522735 to the Replacement Gear and Motor Assembly for RV Slide Out part #LC386735 which is the correct replacement. The third wire on your old motor is for the brake release which is built into the…

view full answer...

Answer 3

I was able to cross reference the slide-out motor 522735 to the Replacement Gear and Motor Assembly for RV Slide Out part #LC386735 which is the correct replacement you need.

view full answer...

Answer 4

The Replacement Gear and Motor Assembly #LC386735 will replace your current slide motor. I reached out to Lippert who took over for Power Gear and they were able to confirm that this is the correct replacement for your motor 522735s.

view full answer...

Answer 5

Hello Danny. We do carry replacement motors, but unfortunately I was not able to find any references for the part number 1469c350 you provided. Are there any other numbers or markings on your motor? Usually there will be a brand and model number on…

view full answer...

Answer 6

A breakaway kit can be wired in one of two ways to the trailer brake system. The first way would be to use the Engager Trailer BreakAway Kit with Charger and Tester, item #20099 , and splice off of the power wire that maintains the trailer's…

view full answer...

Answer 7

Basically you'll be wiring the 12 volt accessory circuit you have now that is charging the current battery also to the breakaway battery so that the charge circuit charges both batteries. Aside from that you'd wire up the breakaway like the…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…

view full answer...

Correct Replacement For Power Gear Slide Out Motor 522735s

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching