Recommended Tools For Cutting Hole In Skid Plate On a 2009 Toyota Tundra For Curt Front Receiver
Updated 12/19/2022 | Published 12/17/2022
Products Featured in This Question
Question:
What does one use to cut the hole in the skid plate?
asked by: Robert J
0
Expert Reply:
There are a few different tools you can use to cut the 4" hole in the skid plate on your 2009 Toyota Tundra. This hole is required so you will be able to access the oil filter after installation of the Curt Front Mount Trailer Hitch Receiver # 31198 on your Tundra. You can use a 4" Hole Saw from our kit # PT34VR, body panel trim saw or a small jig saw to cut out the hole. I recommend removing the panel to prevent any damage to your vehicle when cutting out the hole.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- 5000 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Comparing Curt and Draw Tite Front Hitches for 2018 Toyota Tundra
- Q&A: Availability Of Trailer Hitch For 2015 Lexus LX 570
- Q&A: Front Hitch Installation On A 2022 Toyota Tundra
- Q&A: Front Mounted Trailer Hitch Receiver For 2021 Toyota Tundra
- Q&A: How to Measure for Offset on Trailer Wheel
- Q&A: Is EcoHitch Front Hitch EH89CR Compatible With TRD Skid Plate On 2024 Toyota Tundra?
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Best Bike Racks for Electric Bikes
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Boat Trailer Guides: Which are the Best?
- Article: Rust Prevention