Replacement Wheel for 14,000 Pound Equipment Trailer

Question

Question:

just want to make sure before i order a spare wheel that this wheel fit my new load trial 14k equipment trailer dexter 7k axles it came with rosta wheels 3960 load rating

asked by: Jeff C

0

Expert Reply:

As long as your tires will fit 16" x 6" wheels and your current bolt pattern is 8 on 6-1/2 you can use the Vesper Steel Modular Trailer Wheel # TA77RR for a spare. This has a higher capacity of 4,460 lbs when compared to your current wheels so that will not be a problem.

expert reply by: Robin H

0

Robert H.

8/11/2025

I have this wheel and want to run heavier 16 ply tires. The tires have a max PSI of 115 psi. Are these wheels capable of that pressure? Thx much.

Robin H.

8/12/2025

@RobertH the max psi for the valve stem that comes with the # TA77RR is 110 so you will need to replace the valve stem with # AM20906 which is rated for 200 psi.

Answer 1

I recommend picking up one of the following Taskmaster Mod wheels, which come in these colors: - Black #TA77RR - Silver #TA55VR - White #AM20785 Taskmaster wheels have definitely made an impact on the towing community and have quickly become a go-to…

view full answer...

Answer 2

I have a solution for you but the Provider ST235/80R16 Radial Trailer Tire w/ 16" Vesper Silver Mod Wheel item #TA86FR does not come in black. The tire and an identical wheel but in black are available separately. I have listed them below:…

view full answer...

Answer 3

The pilot diameter on a wheel, like the one with part #AM30620, is the diameter of the bigger hole that is directly in the middle of the wheel. The pilot hole diameter of the wheel for the part I just measured is 2.84". I have attached a picture…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Wheel for 14,000 Pound Equipment Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching