Mounting Dimensions For Folding Step Assist # PLR900
Updated 10/26/2022 | Published 10/20/2022
Question:
What is the diameter of the mounting holes on the step?
asked by: Stan Z
0
Expert Reply:
Per the manufacturer The Folding Assist Step # PLR900 has a mounting hole dimension of 4 inches center on center.
expert reply by:
Noah E
0
Product Page this Question was Asked From
Folding Assist Step - Galvanized Finish
- Trailer Steps
- Folding Step
- 4 Inch Wide
- 4-3/4 Inch tall
- Steel
- Polar Hardware
more information >
Continue Researching
- Q&A: Bike Rack Recommendation for NuCamp 320 Camper
- Q&A: Timken Double Lip Grease Seal To Replace Grease Seal # GS-2250DL
- Q&A: Difference Between Grease Seals # RG06-070 and # GS-2250DL
- Q&A: Difference Between Grease Seal Numbers # RG06-070 And # GS-2250DL
- Q&A: Are Backing Plates Needed for Securing Vehicles with Horizontal E-Tracks
- Q&A: Replacement Grease Seal # 3077 With 2.56-Inch Outer Diameter and 1.74-Inch Inner Diameter
- Q&A: How To Close Gap In Access Opening When Installing Telesteps Telescoping Pull Down Attic Ladder
- Article: Trailer Wiring Diagrams
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Measure for Motorhome Steps
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing