Will The Timbren Suspension Enhancement System Fit A 2022 GMC Sierra 3500?

Question

Question:

Will these work on a 2022 GMC Sierra 3500HD Dually? We are buying a new 5th Wheel that is much heavier than our previous and with a potential of 3700+ Tongue weight we want to avoid any sagging by adding these. I want to make sure I order what will work for our truck.

asked by: Susie L

0

Expert Reply:

Yes, the Timbren Suspension Enhancement System - Severe Service # TGMRTT35D will fit your 2022 GMC Sierra 3500. This system has an 8,000-lbs capacity that will increase stability, reduce rear sag, and will extend the life of your suspension.

Attached is a product review video for you to check out as well.

expert reply by: Bryce D

0

Answer 1

Hey Carl! How much does the Weigh Safe weigh? With all of the parts put together the #WS88RR weighs 35-1/2 lbs. If you need anything else don't hesitate to reach out in the comments below.

view full answer...

Answer 2

Hey David! The Weigh Safe 6" Drop Hitch w/ 2.5" Shank item #WS46ZR weighs 19 lbs.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Will The Timbren Suspension Enhancement System Fit A 2022 GMC Sierra 3500?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching