Electric Brake Assembly Set Replacement for Trailer with Rockwell 5,200 lb Axle

Question

Question:

Thank you Jameson for the fast response! Is there an upgraded option that I should be considering?

asked by: Brent P

1

Helpful Expert Reply:

Rockwell axles use the standard brake assemblies for trailer axles so for a 5,200 lb axle the kit you'd want is the part # AKEBRK-7-D which is Dacromet coated to fight corrosion as well.

expert reply by: Jameson C

1

Brent P.

9/14/2022

Thank you Jameson for the fast response! Is there an upgraded option that I should be considering?

Jameson C.

9/14/2022

There is a self adjusting option with the Dexter Nev-R-Adjust set part # 23-464-465 that would be a solid upgrade. You'd never have to worry about your brakes being out of adjustment.

Answer 1

I recommend the Electric Trailer Brake Kit #AKEBRK-7-D. The dacromet-coated backing plates are corrosion resistant which is ideal for a boat trailer. Both left and right hand sides are included with the kit. The Trailer Hub and Drum Assembly…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Scott! I recommend using the Hydrastar Marine Electric Over Hydraulic Actuator for Disc Brakes #HS381-8067. Hydrastar is a reliable, proven brand so it will serve you well. Then for brake lines you can use the Hydrastar Hydraulic Brake Line Kit -…

view full answer...

Electric Brake Assembly Set Replacement for Trailer with Rockwell 5,200 lb Axle

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching