Can I Use 1/2" Longer Shackle Straps for My Trailer Suspension

Question

Question:

I bought Shackle 1/2 inch too long. Can I still use them?

asked by: Shaun P

0

Expert Reply:

If the shackle straps are within a 1/2" of what you normally had, say the 2-5/8" # 115052 to 3-1/8" # TRSL313, you should be okay to install them. Just make sure that all of your shackle straps match though. If you are using the longer straps only for a section of your suspension setup then that will cause issues for your trailer.

expert reply by: Jon G

0

Answer 1

Hi Mark; I recommend upgrading your shackles as well while you're at it using the Dexter Heavy Duty Suspension Upgrade Kit for Single Axle Trailers #K71-358-00. This includes wet bolts, bronze bushings, and 1/2" thick shackle straps so you…

view full answer...

Answer 2

When replacing shackle straps they should be the same length as the ones that were previously on your tandem axle trailer (if possible); replacing them with longer straps will result in additional play in your trailer suspension which could lead to…

view full answer...

Answer 3

The shackle straps included in the Lippert Tandem Axle Equa-Flex AP Kit - Wet Bolts - 3-1/8" Long Shackles #LC64FR you mentioned are 3-1/8" center to center and 4-3/8" overall length as shown in included diagram. Using the longer…

view full answer...

Answer 4

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 5

We have replacement shackles that are 2-5/8 inches bolt hole center to bolt hole center with the part #115052 but we do not sell these in a kit like you asked about. Then for wet bolts that will work with these that come with matching nuts you'd…

view full answer...

Answer 6

Trailer manufacturers don't usually keep a record of parts like these that they install at the factory, so I cannot be sure as to the exact length of the shackle strap that would have come originally on your trailer. With this in mind, a 3-1/8…

view full answer...

Answer 7

Before you consider re-tapping the threads, re-check to make sure you have the right sized Anode Rod. I reached out to my contact at Suburban and they advised me that your water heater has a 3/4" NPT (National Pipe Threading) and it has 12…

view full answer...

Answer 8

We have leaf spring bolts that were made specifically with features for the leaf spring application like the part #126B2. This is the correct size has a knurled section right below the head of the bolt which helps with install and has a grease…

view full answer...

Answer 9

25-1/4 inch leaf springs are a very common length. For a leaf spring that is rated for a 2,500 lb axle that is 25-1/4 inches long you would want the part #e66SR. If instead you meant 2,200 lbs per spring you would want the #e44SR instead.

view full answer...

Answer 10

Most likely the measurement is 25-1/8 inch as that is a common size. But in most cases we recommend measuring the spring with it off the trailer and typically there is a bit of stretch to old springs by around 1/2 inch or so. The spring you would…

view full answer...

Answer 11

Hey Adam, 24-5/8" is a standard sizing for 2,000lb leaf springs so the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles - 24-5/8" Long #e69SR is what you need. It unfortunately doesn't look like we offer a slipper spring…

view full answer...

Answer 12

Finding replacement leaf springs for your 1967 Aristocrat camper will require some more information. You will need your axle capacity, current leaf spring length, and the shackle length. If you don't know your axle capacity, try checking the axle…

view full answer...

Can I Use 1/2" Longer Shackle Straps for My Trailer Suspension

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching