Wet Bolt Kit for 2025 Keystone Coleman Light 17RX

Question

Question:

2025 Keystone Coleman Light 17RX. Want to replace bushings and add wetbolts, single 4k Terran axle. What bushings/wetbolts do I need?

asked by: Mark B

0

Expert Reply:

Hi Mark; I recommend upgrading your shackles as well while you're at it using the Dexter Heavy Duty Suspension Upgrade Kit for Single Axle Trailers # K71-358-00. This includes wet bolts, bronze bushings, and 1/2" thick shackle straps so you can have confidence they will last. If you're set on just replacing the bolts and bushings you can use the # D014-077-00 and then for the wet bolts # LC126197.

Any big trips coming up with your 2025 Keystone Coleman Light 17RX?

expert reply by: Robin H

0

Dexter Heavy Duty Suspension Upgrade Kit
(click to enlarge)

Mark B.

7/13/2025

Thanks, Robin! We have 2 trips to the Oregon coast planned for early August. I learned years ago to replace OEM nylon bushings w/bronze bushings & wet bolts after discovering our Grand Design Imagine 2500RL had them. I’m amazed that any legitimate RV manufacturer uses nylon bushings.

Robin H.

7/13/2025

@MarkB that sounds really nice! I haven't been to Oregon in a really long time but would like to take my kids up there. Unfortunately, even the most reputable manufacturers tend to use the cheapest parts they can get at the time. Some of these small parts can easily fail and lead to a bad day, especially if you're using the trailer a lot and don't know what to check for. The first thing I did on my trailer was swap out the bushings and add wet bolts and upgraded shackle straps so I don't have to worry about it.

Mark B.

7/13/2025

@RobinH I'm also installing a MorRyde X-Factor Brace on each spring eyelet, so I don't think this setup will work. I need the wet bolts to be 9/16 x 3-3/8".

Robin H.

7/15/2025

@MarkB we can still make that work with the MORryde X-Factor # MR33WR by piecing it together using # LC126197 for the wet bolts and # K71-291-00 for the bushings. If you want the heavy duty shackles those can also be picked up separately # DX55FR.

Answer 1

Hi Nate, The quick answer to your question is yes! All our tire and wheel combinations come with the tire mounted on the wheel so they're ready to go! They are also aired up to the correct pressure before shipping and are balanced straight from…

view full answer...

Answer 2

Hey Darla, the correct MORryde X-factor for trailers that have a MORryde CRE3000 kit installed is the standard kit part #MR33WR. Running three of these would give you the most stable setup so that would be what I would recommend.

view full answer...

Answer 3

Hello Jacques, thanks for reaching out. Yes, you can put just one MORryde X-Factor Crossmember #MR33WR on the center hanger for starter. MORryde does recommend doing all 3 for optimal support, but it is perfectly acceptable to start with just one as…

view full answer...

Answer 4

Hello Daniel, We may have the right bearings and seal for your Coleman trailer but don't have any parts specifically for a Terran axle. So in order to find the correct kit you will need to take apart your current hub assembly and look at the…

view full answer...

Answer 5

Hello again Adam! Since you have 7k Lippert axles the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers #RM-2460-2570 is the correct kit. This is going to be a significant improvement over the stock suspension. For wet bolts you…

view full answer...

Answer 6

Hello Rene, thanks for reaching out. It is pretty typical for RV manufacturers to use axles that are not rated for the full GVWR. They say this is because 10%-15% of the camper weight is on the hitch instead of the axles. They will put the bare…

view full answer...

Answer 7

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 8

If you are going to install two of the MORryde X-Factor Crossmembers #MR33WR on your tandem axle trailer Alan you would want to install them on the front and rear hangers. You can install a third one if you want on the middle hanger as well for even…

view full answer...

Answer 9

Hello Steve, Yes, you can most definitely add helper springs! This is a great way to improve your ride quality better while towing. I see that the 2020 Grand Design Solitude Fifth Wheel comes with 2 axles rated at 7k so you will want one of the…

view full answer...

Answer 10

Hey Chad; since your tandem 3,500 lb axles have a 3" diameter you need the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers #RM-2460-2560. The kit comes with everything you need for installation aside from standard tools.…

view full answer...

Answer 11

If the shackle straps are within a 1/2" of what you normally had, say the 2-5/8" #115052 to 3-1/8" #TRSL313, you should be okay to install them. Just make sure that all of your shackle straps match though. If you are using the longer…

view full answer...

Answer 12

We have replacement shackles that are 2-5/8 inches bolt hole center to bolt hole center with the part #115052 but we do not sell these in a kit like you asked about. Then for wet bolts that will work with these that come with matching nuts you'd…

view full answer...

Wet Bolt Kit for 2025 Keystone Coleman Light 17RX

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching