How To Wire and Install the Starter Solenoid PK5230701
Updated 08/11/2022 | Published 08/10/2022
Question:
It would be helpful to tell the people WHAT IS THE CONNECTION TO THE GROUND left or right pole from the picture. This is for a 2006 Pontiac Montana small engine. Also, please advise where to place the unit. Thanks, Looking forward to your early reply.
asked by: Mike M
Expert Reply:
In regards to the Starter Solenoid part # PK5230701, the larger terminals are for power in and out. The smaller terminals are for ignition/remote and ground. It does not matter which side goes where. The solenoid is designed to be mounted vertically, with the cap facing downward. It should be mounted in an enclosed area, but not in the engine compartment.
Product Page this Question was Asked From
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Insulated - UL Listed
- Accessories and Parts
- Battery
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Continue Researching
- Video: The Low-Down on the 2-Pole Socket Connector
- Shop: 2-Pole Trailer Wiring Connector - Trailer Side
- Shop: 2-Pole Socket Connector - Vehicle Side
- Q&A: What are the Functions of the Posts on the 12 Volt, 100 Amp Starter Solenoid
- Search Results: 6 gauge wire
- Search Results: wire
- Search Results: trailer wiring
- Shop: Spectro Stackable Electrical Quick-Connect - 2 Gauge - 175 Amps - Gray - Qty 1
- Shop: Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Insulated - UL Listed
- Shop: Pollak Trailer Connector Adapter - Vehicle End - 7-Pole Round to 7-Way Blade
- Shop: Primary Wire Heat-Shrinkable Tubing - 14-10 Gauge - Black - 3/16" Diameter - 6" - Qty 25
- Shop: Buyers Products 2-Way Die-Cast Zinc Trailer Connector - Truck Side - Horizontal Pin Arrangement
- Video: All You Need to Know About the 2-Pole Trailer Wiring Connector
- Video: Replacement Phoenix USA Rear Wheel Center Cap Feature Review
- Search Results: bracket
- Q&A: Recommended Replacement Electric Trailer Brakes For 7000lb Dexter Axle
- Q&A: Replacement Converter for WFCO WF-68100
- Q&A: What Winch Cover Fits My Superwinch SX10SR to Avoid Snow and Dirt?
- Q&A: Is There Replacement Flush Ball for Dometic 310 Toilet
- Q&A: Trailer Hub Dust Cap with a 2.125" Outside Diameter
- Q&A: Replacement Hitch Head Assembly Needed For Reese Weight Distribution Hitch
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Wiring Diagrams