Most Reliable Ratcheting Cargo Bar for Full Size and Compact Truck Beds

Question

Question:

Hello, I was looking for a recommendation for a sturdy ratcheting cargo bar for my 2019 f- 350 super duty. Thank you

asked by: Steve W

0

Expert Reply:

I would be happy to help. Most standard truck bed widths are right at 72 inches. For your 2019 Ford F-350, I recommend the Erickson Cargo Control Cargo Bar with Ratchet item # 08908. This cargo bar has an adjustable length of 44" to 74". It has a ratcheting lever that secures the bar into place and the rubber foot pads ensure a good grip and won't scratch up your bed or bed liner.

expert reply by: Jerred H

0

Answer 1

Hey Tyler, thanks for reaching out! Yes, the Fas-Top Traveler Roll-up Tonneau & Soft Truck Topper Combo #FT38RV is confirmed to fit the standard bed on your 2020 Chevy Silverado 3500. Do you plan on mainly using it as a tonneau cover or as the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 9

Hey Jerry, GM moved the placement of their puck systems starting with 2020 models so you are correct that the pucks would have the hitch not sit directly over the axle. GM did the math and made sure that this placement wouldn't adversely affect…

view full answer...

Answer 10

Hi Richard! From the top of the shank to the lowest part where the tri-ball sits on the #BWTS20067BMP is 11.125". If you have the balls at max drop with the tallest one hanging down that would be 12.5". We recommend at least 11" of…

view full answer...

Answer 11

Hi Hilario, congrats on the new truck! ^___^ If this were my truck and I was installing a retractable cover on it (which I actually did with my Silverado), I would go with the manual RetraxPRO XR Hard Tonneau Cover - Retractable - Aluminum - Matte…

view full answer...

Answer 12

Hey Larry! Yes, the Onan Generator - QG 7000i Onboard RV Generator #CM44MR is capable of using a remote start. For a standard setup, you can use a switch like #CM86RR along with an extension harness #CM26RR. You can also use the EC-AGS+ Auto…

view full answer...

Most Reliable Ratcheting Cargo Bar for Full Size and Compact Truck Beds

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching