How to Find Replacement Hubs for 1993 Skamper 17X Pop Up Camper

Updated 08/02/2022 | Published 07/30/2022

Products Featured in This Question

Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2

(94)

$67.16

Trailer Idler Hub Assembly for 2K Axles - 10" to 12" Wheels - 5 on 4-1/2 - Pre-Greased

(1479)

$43.37

Replacement Trailer Hub Bearing - L44643

(2138)

$6.42

Replacement Trailer Hub Bearing - L44649

(2138)

$22.32

4" Carbon Fiber Digital Caliper

(26)

$11.93

Question:

I want to put new hubs on this pop up. i had a tire come off on me on my first trip with it. it has bolt on, and i want stud with wheel nuts. Any idea of what hub will fit? are the pre greased ready to go on the spindle?

asked by: Larry W

Expert Reply:

Based on what I was able to find, your 1993 Skamper 17X more than likely has 2,000 lb axles. If that is the case, you will either have a # L44643 inner and outer bearing or # L44649. You will need to verify this information.

You can inspect your current bearings to see if they have part numbers stamped on the side. If none are present, or they have worn off, you will need to measure. I recommend using a digital caliper like the # PTW80157. The measurement you need is the inner diameter of the bearings. Alternatively, you can measure the spindle where the bearings ride.

If you have an inner diameter of 1.00" then you can use the Dexter Trailer Idler Hub Assembly # 34822545BX you were looking at. If the inner diameter is 1.063" then you have # L44649 bearings and you could use the # AKIHUB-545-2-2K.