Replacement Control Panel for Lippert Electric Ground Control Jack Systems

Question

Question:

Our control panel went out willbthis one work? 2019 vengeance 40d 12

asked by: Stephanie H

0

Expert Reply:

I am not sure what control panel you have on your 2019 Forest River Vengeance Touring Edition 40D. If you have the Ground Control 3.0 you will need the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System item # LC421484.

The Replacement Touch Screen Control Panel for Lippert Ground Control TT or Lippert OneControl - 5" item # LC83VR will only work with the Lippert OneControl systems and the the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System item # LC672136. You most likely need the If you do not have this ground control system or a Lippert OneControl then please email me back with which one you do have and I will be more than happy to find a control panel that will work for you.

expert reply by: Jerred H

0

Answer 1

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

view full answer...

Answer 2

In order to test the controller on the Lippert Ground Control 3.0 Electric Leveling System you'll first need to obtain a multimeter. Once you have this then you will need to use the ground probe and place that on the green wire coming from the…

view full answer...

Answer 3

According to my research you can use your smart phone instead of the OneControl touch screen if you have the Wi-Fi Gateway Hub for Lippert OneControl Systems #LC45UD. However, I do recommend replacing the Touch Screen #LC83VR as well just in case you…

view full answer...

Answer 4

I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system won't reset. He…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 11

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Replacement Control Panel for Lippert Electric Ground Control Jack Systems

Products Featured in This Question

Continue Researching