What is Pin Diameter of 2-5/16" Gooseneck Coupler Head # 291300

Question

Question:

What is the diameter of the pin that secures this coupler?

asked by: Stetson

0

Expert Reply:

The pin of the 2-5/16" Gooseneck Coupler Head # 291300 that you referenced is 1/2 inch.

expert reply by: Jameson C

0

Answer 1

The 2-5/16" Gooseneck Coupler Head part #291300 can be locked using the Tow Ready Base Rail Lock part #TR63254.

view full answer...

Answer 2

Based on the dimensions for the Truck Lite Model 60 that you have it matches the Optronics 10-LED Trailer Tail Light #STL72RB so this light will work as a replacement for you. The 48-LED version #STL70RB that you referenced is the same size and will…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

What is Pin Diameter of 2-5/16" Gooseneck Coupler Head # 291300

Product Page this Question was Asked From

Continue Researching