Base Plate Kit for 2007 Jeep Liberty That Works w/ Blue Ox Tow Bars and Other Flat Tow Parts Needed

Question

Question:

What base plate would I need on a 2007 Jeep Liberty to use my my blue ox tow bar on? Also what wiring kit would be needed…tail lights, emergency brake and battery charging when being pulled? Thank you.

asked by: Steve C

1

Helpful Expert Reply:

For your 2007 Jeep Liberty you can use the Demco Tabless Base Plate Kit # DM9519181 which is confirmed to fit the 2007 Jeep Liberty without brush guard and is compatible with Blue Ox tow bars.

For wiring to operate the tail, brake, and turn signal lights for flat towing your 2007 Jeep Liberty I recommend the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267 which allows you to use your Jeep Liberty's tail lights and wiring system while preventing feedback from your RV.

To keep your battery charged you can use the Roadmaster Battery Charge Line Kit for Towed Vehicles # RM-156-25 for your Liberty. You may also need the Roadmaster Battery Charge Line Kit for Motorhomes # RM-156-75 if your Motorhome doesn't already have a charge line present.

I have listed a couple more parts that you'll need to flat tow your 2007 Jeep Liberty, just in case you do not already have them.

- Safety Cables: Blue Ox 7' Safety Cables # BX88197

- Supplemental Braking System: Demco Stay-IN-Play DUO Supplemental Braking System # DM86VR

expert reply by: Scott S

1

Answer 1

To flat tow a vehicle, you'll need a hitch on the motor home, a towbar, a base plate kit installed on the tow vehicle, a tow bar wiring kit so that the taillights on the vehicle work along with those on the motor home, safety cables and a…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Base Plate Kit for 2007 Jeep Liberty That Works w/ Blue Ox Tow Bars and Other Flat Tow Parts Needed

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching