Is the Progressive Dynamics PD4560CSV Compatible With the PD4560K18NS2B

Question

Question:

The converter section died used the trouble shooting instructions on their web site and I need need to know if this converter works with my present converter which is a Progressive Dynamics PD4560K18NS2B. Is this part PD4560CSV Compatible with my converter.

asked by: Joseph J

0

Expert Reply:

The Progressive Dynamics converter section part # PD4560CSV that you referenced is the correct replacement for what you have now. If you were wanting to go to lithium batteries by chance you'd instead need the # PD4560LICSV.

expert reply by: Jameson C

0

Answer 1

Yes, you do need to move the jumper over from the lead acid to the lithium setup and you'd have the higher voltage charging profile.

view full answer...

Answer 2

The Progressive Dynamics Lithium Converter #PD4560LICSV will replace the 4500 series converter you have installed in your RV currently and will allow you to use Lithium batteries.

view full answer...

Answer 3

The replacement solution you are in need of is the part #PD4560K18LS8. This replaces the panel/converter you have now with basically the exact same thing but comes with ability to change between lead acid an lithium profiles.

view full answer...

Answer 4

Hey Wade, since the Progressive Dynamics Panel part #PD4560K18LS8 uses Wago 221 connectors the max gauge wire it can be used with is 10 gauge. What gauge wire were you planning on using?

view full answer...

Answer 5

Hey Justin! With the current Progressive Dynamics REL 60A 4500 Series Inteli-Power Converter Section #PD4560CSV you'll either need to make a jumper or you'll just need to go with the Converter Section #PD4560LICSV instead, so your power…

view full answer...

Answer 6

The Converter #PD4560CSV is the correct replacement for your PD4560K18NS2 as long as you are using lead acid batteries. If you have upgraded to Lithium batteries you will need the Converter #PD4560LICSV to prevent damage to the batteries.

view full answer...

Answer 7

The Progressive Dynamics #PD4560K18LS8 is a power center which includes a converter/charger for lead acid or lithium batteries. The converter control board has a tiny switch on it that can be set to "LI" for lithium or "LA" for…

view full answer...

Answer 8

If you're just wanting to replace the converter cross section of your PD4560 power center to be compatible with lithium batteries then yes, you'll want the Replacement Lithium Converter for Progressive Dynamics 4500 Series RV Power Control…

view full answer...

Answer 9

I have a solution for you to replace your converter, but you're not able to upgrade to a 90 amp converter like the Replacement Converter Section for Progressive Dynamics 4500 #PD4590CSV because your current electrical system likely isn't set…

view full answer...

Answer 10

The Progressive Dynamics 4000 Series RV Converter part #PD4060K is already lithium compatible, there's a switch on the circuit board of the converter section which you will flip when charging lithium batteries. I have attached for you below a…

view full answer...

Answer 11

Hello Chris; yes, the Replacement Converter Section #PD4045CSV is compatible with the "non KA" model of the PD4045K power center. This has been confirmed directly with the folks at Progressive Dynamics.

view full answer...

Answer 12

The Replacement Converter Section for Progressive Dynamics 4000 Series RV Power Control Center #PD4045CSV is a fit for the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger #PD4045KA. If you don't already have a…

view full answer...

Is the Progressive Dynamics PD4560CSV Compatible With the PD4560K18NS2B

Product Page this Question was Asked From

Continue Researching