Replacement Upper and Lower Track Strips for Thule Evo Crossbars

Question

Question:

I bought a Thule Evo Flush Rail from Subaru for my 2018 Outback Touring in 2019. I need replacement of the two U-shaped rubber strips that are used to prevent the rails from sliding. Please advise. Thank you

asked by: Ken W

0

Expert Reply:

For the Thule Evo roof rack crossbars we have the top t-track strip part # 1500052989 and the lower rubber strip part # TH79VW as well.

expert reply by: Jameson C

0

Answer 1

Hey Genya, thanks for reaching out and giving me all of the details! The correct replacement strip for the Thule WingBar Edge Roof Rack #TH86RG on your 2015 Audi A3 is the Kit #1500052989, which is just 2 sets of the 54242 that you found on the Thule…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 7

Hello David, great question. So, there is a chance that you will have to enlarge the access holes for the both the etrailer #e98912 hitch and the EcoHitch #306-X7365. Both hitches come with the same size spacers. The picture below will help…

view full answer...

Answer 8

Hey Howard, thanks for the information. The Malone AirFlow2 Roof Rack item #MAL74AR, you referenced, will indeed fit the raised roof rails on your 2024 Subaru Crosstrek WILDERNESS edition. These 50" long x 3" wide x 1" tall crossbars…

view full answer...

Answer 9

Hi Marcy! The etrailer hitch for your 2024 Subaru Crosstrek is the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" #e98912 you found. We did an install of this on a 24 Crosstrek and I have that video included.…

view full answer...

Answer 10

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 11

Hey Jim, You are right that both of those hitches, #C13382 and #C22MJ, fit a 2025 Crosstrek. Capacity wise these hitches are rated for the same 3,500lb capacity. The main difference comes down to the trim of the vehicle. The #C22MJ is not intended…

view full answer...

Answer 12

It sure does! The etrailer Hitch item #e98912 has been confirmed to fit the 2024 Subaru Crosstrek Wilderness.This hitch is custom fit and bolts to your Subaru with included hardware. This is a class III hitch with a 2" receiver. It has a 3,500…

view full answer...

Replacement Upper and Lower Track Strips for Thule Evo Crossbars

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching