Distance From Closest Hitch Pin Hole to Upright on etrailer Hitch Mounted Spare Tire Carrier

Updated 04/04/2022 | Published 04/03/2022

Question:

Please let me know the distance from the hole closest to the vertical bar at the weld. Does the 3 3/4” spec measure to the bar or the triangle reinforcement piece between them. What is the distance from the hole center to the triangle piece? Thanks

asked by: Jerry K

Expert Reply:

The 3-3/4" measurement is measuring to the triangle piece/gusset. This does have some slight variation depending on the weld. After measuring I found that the distance from the center of the closest hole to the base of the gusset is approximately 4". The distance from the closest hole to the upright is 7".

expert reply by: Robin H