Replacement Lift Gear and Motor for Ventline Model V2119

Question

Question:

My powered vent Ventline Model V2119 will not stay closed. It flops up and down when the wind blows. I assume a gear has been stripped inside the motor. It looks like the replacement unit that I would need is: Item # V2119-601-00. My question is whether or not the motor is sold separately and does the motor have the gears inside that raise and lower the vent and hold it in place? Thanks!

asked by: Chris C

0

Expert Reply:

If the lift motor on your Ventline # V2119-601-00 runs when you try to operate it then it sounds like you need the Replacement Plastic Gear # BVD0121-00 which operates the lift arm.

To replace the lift motor you need the Replacement Gear Motor with Pinion Gear # BVB0601-00.

expert reply by: Jon G

0

Answer 1

According to my contact in the engineering department at Ventline, the cause of what you have going on is a damaged operator. The operator is the linkage between the motor and the vent lid. Look at the photo I've provided. If the housing around…

view full answer...

Answer 2

Hello Greg, The CCI Controls model number 7719 LP gas leak detector is an older model and it is recommended to replace it due to its age and potential for sensor failure. For a Propane gas detector replacement, I would go with the RV Propane Gas…

view full answer...

Answer 3

Hello Mike. I am sorry to hear you are having issues with your new lid not staying on, thank you for the pictures as they are always very helpful. So with the lid blowing off like that and replacing it with a new one it could be a couple of different…

view full answer...

Answer 4

It sounds like the lift motor is no longer operating, but with the fan still working it does not seem like power supply is the problem. More likely that the motor is malfunctioning. We do have the replacement lift motor available for a V2119 like the…

view full answer...

Answer 5

It's hard to say exactly what's wrong with your roof vent fan without physically inspecting it and all the components. That said, the fan not working is usually a motor issue so if you have power going to the motor but it still won't turn…

view full answer...

Answer 6

I believe we have what you need. If you are looking for a replacement gear for a Ventline ventadome roof vent then you need the Replacement Plastic Gear for Trailer Roof Vent, Item #BVD0121-00. This fits items like the Ventline Ventadome Roof Vent,…

view full answer...

Answer 7

The Replacement Gear Motor with Pinion Gear #BVB0601-00 is the correct replacement for the Ventline Ventadome roof vent model V2119. It sounds like you also need the Replacement Operator, Knob and Screw for Ventline Ventadome Trailer Roof Vents…

view full answer...

Answer 8

You can utilize a power wall remote switch #VC0533-03-A or #VC0533-02-A (black or white). A rocker switch #BL0108-00 will work and you will need 2 of them. The installation kit #344270KITW will come with screws, tape, and sealant. You will also need…

view full answer...

Answer 9

The only stand-alone replacement plastic gear for Ventline Ventadome Trailer vents that we offer is part #BVD0121-00. This part works with roof vent model V2119.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Replacement Lift Gear and Motor for Ventline Model V2119

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching