Wiring Harness Adapter for a Brake Controller on a 2018 Ford E-350 Motorhome

Question

Question:

I had purchased the item #22292 from Amazon as it said it fit the E350, it did but not. My controller is a Tekonsha P3 90195. The item #3034-P wire layout appears to match the E350 plug better. Is this the correct part I need? Thanks. I dont have a picture handy.

asked by: Robert W

0

Expert Reply:

The Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3034-P is compatible with the Tekonsha Prodigy P3 Trailer Brake Controller # 90195 and the 2018 Ford E-series Cutaway which is what your motorhome would have been built on. This is the correct harness for you.

We have had a number of people use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3034-P successfully on their E-series Motorhomes.

expert reply by: Scott S

0

Answer 1

The brake controller install harness you need to install the Tekonsha Primus IQ part #TK90160 in your 2018 Ford E-450 is the part #3040-P. The brake controller plug will be located behind the dash in one of two places, as you can see in the photos…

view full answer...

Answer 2

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 3

The correct brake controller install harness for your 2018 Ford F-450 is the part #22292 and there is two possible locations for where to find the connector on your truck. Most of the time it's below the dash behind the steering column. The other…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Wiring Harness Adapter for a Brake Controller on a 2018 Ford E-350 Motorhome

Featured Help Information

Miscellaneous Media

Continue Researching