Do the Taylor Made Bimini Top Aluminum Slide Assemblies Have Locks in the Track

Question

Question:

When the Bimini top is up in use, does the slide lock in place, or does it move around? Worries about the top sliding forward or back while under way. Thank you.

asked by: Matt

0

Expert Reply:

There are not track locks on the Taylor Made Bimini Top Aluminum Slide Assemblies # 369993030. There are endcaps that cover the ends of each track to keep the sliders from falling out but no progressive locks in the track to keep it from shifting back and forth when the top is up and underway.

expert reply by: Scott S

0

Answer 1

Hey Tom, for the Taylor Made Bimini Top Aluminum Slide Assemblies #369993030 you can use the Taylor Made Bimini Top Deck Hinges for Boat Gunwales #3691204.

view full answer...

Answer 2

Bimini tops when properly installed can be opened up while on the water. The tracks part #369993030 are designed to have the hinges part #36911717 installed on them to provide the base for the bimini poles. These have to face up so that the pole…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Yes, it will Bob. The Dometic RV LP Gas Furnace item #DMC64MR is also a 35,000 btu furnace that heats with LP gas and 12V power. It measures 20" deep x 7" tall x 16-1/2" wide. It can be installed in a horizontal or vertical…

view full answer...

Answer 7

The Advent Air RV Air Conditioner #ACM150B will fit in place of your Dometic Brisk Air 2 air conditioner. This will plug directly into your Dometic controller and will work with your current InCommand system including your current air distribution…

view full answer...

Answer 8

Hey there Ross; thanks for that info and your 15,000 Btu Dometic Brisk Air II AC can absolutely be replaced by an Advent unit. I do recommend going with the low-profile option as not only does it look better, but the less height you can add on top of…

view full answer...

Answer 9

Yes, you can definitely use roller bunks with your 21 foot pontoon boat. Roller bunks have capacities, and while pontoon boats can obviously vary quite a bit in weight, roller bunks with a 3,000 lb boat capacity should be for that size boat. I…

view full answer...

Answer 10

You could use roller bunks such as #DL21740 on a pontoon boat trailer. If the pontoons sit on carpeted bunks and support the boat then you would need to place rollers the whole length of each of the carpeted bunks. Set #DL21741 is rated higher at…

view full answer...

Do the Taylor Made Bimini Top Aluminum Slide Assemblies Have Locks in the Track

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching