What Are The Dimensions Of The Replacement Bolt-On Mounting Bracket For Fulton XP Series Jacks

Question

Question:

What are the measurements of the 4 bolt holes in the center part of this bracket?

asked by: JT

0

Expert Reply:

I went out to our warehouse and measured the 4 holes in the center of the Replacement Bolt-On Mounting Bracket for Fulton XP Series Jacks # F500349, and they measure 3" on center left and right, and 3" on center up and down.

The remainder of the bracket measures, 5-1/2" from the furthest left and right holes, 4-7/16" from the outer holes up and down, and 2-1/2" for the inside holes in between the outer holes.

expert reply by: Bryce D

0

Replacement Bolt On Mounting Kit For Fulton XP Measurements
(click to enlarge)

Fulton XP Bracket Dimensions
(click to enlarge)

Answer 1

I have the perfect replacement trailer jack for your 2006 Mastercraft X-Star boat trailer. For this, I recommend using the Fulton F2 Swing-Up, Wide-Track Trailer Jack part #F1413050334. It has a 1,600 lb. capacity and can raise your boat trailer up…

view full answer...

Answer 2

The Fulton F2 Swing-Up, Wide-Track Trailer Jack, 8" Single Wheel, Sidewind, Bolt-On - 1,600 lbs #F1413040134 or weld on version #F1413050334 are both available as complete units but there is not a replacement part available for what you are…

view full answer...

Answer 3

We were able to measure for you the Demco Safety Cable Extensions #DM9523064. As you can see by the accompanying diagram, the entire length of the extension is 16-1/4 inches, the cable by itself is 12-5/8 inches and the hook is 4-1/2 inches. I have a…

view full answer...

Answer 4

I spoke to my contact at Roadmaster about the RoadMaster 8" Safety Cable Extensions part #RM-910648-8 and they stated that each cable is rated for 8,000 lbs but that does not means it will give you 16,000 lbs in total as if one were to break,…

view full answer...

Answer 5

I just heard back from Demco and their 12" Long Safety Cable Extensions item #DM9523064 are 1/4" in diameter.

view full answer...

Answer 6

I am not aware of a bolt-on version of the Buyers Products Weld-On Safety Chain Retainer part #3375471000. However, if all you were wanting to do is mount your safety chains to the tongue of your trailer then you will just simply do so by running a…

view full answer...

Answer 7

Hey Tim. There are only two jacks that will fit your current mounting bracket and they are both Fulton F2 jacks rated at 1,600 lbs. I have listed them below: Fulton F2 Swing-Up Trailer Jack, Dual 7" Wheels, Sidewind item #F1413060334 Fulton F2…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

What Are The Dimensions Of The Replacement Bolt-On Mounting Bracket For Fulton XP Series Jacks

Continue Researching