Do You Need To Put A Fuse In-Line When Installing A Roof Vent Fan.

Question

Question:

I’m installing a 7500K fan and would like to know what size of fuse to use a n the circuit? I’m talking about the 12 volt dc. Thank you

asked by: Kenny G

0

Expert Reply:

In general you do not need to install inline fuses with roof vents like the MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke # MA00-07500K.

If you are doing a normal install there is no need for an in-line fuse. If you do however still want to use a fuse to be extra cautious a 5 AMP fuse will do the job you are looking for.

expert reply by: David B

0

Answer 1

Natalie, that depends on how your RV is set up. If your existing power center has a converter that isn’t lithium-friendly and can’t be replaced on its own, swapping the entire power center can be the cleanest solution. Units like the PowerMax 45A…

view full answer...

Answer 2

Hey Mark, I did some digging and was able to find your Decker 1042 door latch, and it looks like it has a 2 7/8" x 3 3/4" cutout. While we don't have a direct replacement, we do have the Bauer Products Camper Door Lock #BA54FR, which…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Do You Need To Put A Fuse In-Line When Installing A Roof Vent Fan.

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching