Will Conduit Clamp Set for Rhino-Rack Heavy-Duty Crossbars Work with Aero Crossbars

Question

Question:

Wil these clamps fit my rhino rack vortex bars? they seem to have the same C-channel, just asking to confirm. Thanks in advanced

asked by: Jonathan

0

Expert Reply:

The Conduit Clamp Set for Rhino-Rack Heavy-Duty Crossbars part # RRBC2 is designed for the Rhino Rack Heavy Duty Crossbars. The Rhino Rack Vortex Pipe Clamps for Conduit Carriers part # RRSPC4 are designed for Rhino Rack Vortex Aero Crossbars. The two are not cross-compatible as the channels are not the same.

expert reply by: Conner L

0

Answer 1

I suppose you could drill a hole into your conduit carrier, and use the Replacement Square Head Bolt for Thule Fairings #853-208909 with a M6 nut to secure the conduit carrier to your Thule AeroBlade Edge Roof Rack. Or You could use the Conduit Clamp…

view full answer...

Answer 2

Yes, the Conduit Clamp Set for Rhino-Rack Heavy-Duty Crossbars part #RRBC2 will fit the top channels of your Thule load bars.

view full answer...

Answer 3

The Thule WingBars, like part #TH711200 have a top opening of 1/2 inch and a 3/4 inch width at the bottom.

view full answer...

Answer 4

The Conduit Clamp Set #RRBC2 that you referenced is designed specifically to mount to the C-channels that are present on Rhino-Rack Heavy Duty Crossbars. These particular model bars feature a unique C-channel that differs from the standard opening on…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hey Roy, congrats on the new SUV! Listed below are the parts you'll need to add a roof rack to your 2026 BMW X3 that will allow you to have enough clearance for a lift assist kayak carrier or two. This setup is designed for the 2026 X3's with…

view full answer...

Answer 10

Good morning Lisa! Yes these two brands come up a lot since they are both great quality, name brand options. NOCO makes solid jump starters like the 1,250A #NOC48VR, but one big advantage of Projecta models like the #VX63NR 1,200A and #VX73NR 1,400A…

view full answer...

Will Conduit Clamp Set for Rhino-Rack Heavy-Duty Crossbars Work with Aero Crossbars

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching