Recommended Replacement Ladder for 2019 Thor Freedom Elite

Question

Question:

What is the best replacement ladder for a 2019 thore freedom elite ?

asked by: Ralph S

0

Expert Reply:

Yes, the Stromberg Carlson RV Exterior Ladder w/ Hinges, # LA-401BA will work as a replacement ladder for your 2019 Thor Freedom Elite provided all fasteners are properly mounted to the RV's blocking or subframe on roof. The legs of this ladder can be trimmed as needed to provide for a custom fit.

Please note the linked product review and installation video.

expert reply by: Michael R

0

Answer 1

The Stromberg Carlson #LA-401BA has a hinge that can be installed where the two ladder pieces join, which can help with any odd shapes on the rear of your coach. These are typically used on travel trailers but they can also be used on Class A or…

view full answer...

Answer 2

We do have a potential solution for you, but I will tell you up front that we do not offer a direct replacement for your Direct Vent Water Heater Model SW6D. What we recommend as a replacement is the Furrion RV Tankless Water Heater #FR98SR. This…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hi Donny; after looking at several videos of the trailer it does appear to have a 6 on 5-1/2 bolt pattern with ST225/75R15 tires. The Goodyear Endurance ST225/75R15 Radial Tire w/ 15" Eagle Aluminum Wheel #GY97QB will be a direct fit.

view full answer...

Answer 11

Hey Cody, what you'd need is the Progressive Dynamics panel part #PD4560K18LS8 which would replace everything you have now as there isn't just a lithium converter section available for what you have that you can replace what you have with.

view full answer...

Answer 12

Hey Brian, the length of the Stromberg Carlson Stand Off part #SC44SR is 5 inches. What length are you in need of?

view full answer...

Recommended Replacement Ladder for 2019 Thor Freedom Elite

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching