How to Remove the Rotor on 12k Dexter Disc Brake Kit
Updated 11/08/2021 | Published 11/06/2021 >
Question:
I am curious to know how to remove/replace the rotor on a 12k dexter disc hub. I see that there are rotor mounting studs but how am I supposed to remove/install them? Is there a particular tool or am I supposed to replace with new?
asked by: Dominic B
Expert Reply:
When removing the rotor on your 12k Dexter disc brakes, all you need to do is pull it off of the hub assuming you have already removed the caliper. The only thing that secures it to the studs is the wheel and lug nuts when you put the wheel on. It is possible that yours is giving you some difficulty if dirt or rust has built up in some way, but you should still be able to take it off. Just be careful to not damage anything else when trying to break it loose.
I have attached a video from the Kodiak # K2R1258L12 disc kit where you can see this. Starting at 2:30 you will be able to see how the rotor slides over the bolts, followed by the installation of the caliper, and is eventually secured once the wheel is on.
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 12,000-lb Axles - 8 on 6-1/2 - Oil Bath
- Trailer Hubs and Drums
- Idler Hub
- Oil Bath
- 3984 / 28682
- Standard Grade
- For 12000 lbs Axles
- 5/8 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: tst~507
- Search Results: window seal
- Q&A: Replacement Sensor for TST Tire Pressure Monitor System
- Shop: TST TPMS for Trailers and Cars - Color Display - Signal Booster - 8 Cap Sensors
- Shop: TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors
- Shop: Trailer Hitch
- Shop: Optronics Incandescent Trailer Clearance and Side Marker Light - Submersible - 2 Bulbs - Red Lens
- Shop: Rubber Window Edge Weather Strip for RVs - Press In - 30' Long x 19/32" Tall
- Shop: Rubber Window Edge Weather Strip for RVs - Press In - 12' Long x 1/2" Tall
- Shop: Optronics Incandescent Trailer Fender Light - Submersible - 2 Bulbs - Red/Amber Lens
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Optronics Trailer Lights A65PB Review
- Video: Optronics Sealed Thin Line Two-Bulb Trailer Clearance Light Installation
- Video: Hands-On with the Rubber Window Edge Weather Strip for RVs
- Video: Detailed Breakdown of the Replacement 11" Rotor for Dexter Disc Brakes
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Search Results: trailer hitch
- Search Results: trailer wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Suspension Enhancement
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Brake Controller
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer tires and wheels
- Shop: Base Plate for Tow Bar


