How To Remove Control Dial From Redarc Tow-Pro Liberty Brake Controller

Question

Question:

We accidently put the knob on before turning controller, so now its not correct with zero on top. How do you get it back off to place in correct location? We tried just pulling, but dont want to break anything.

asked by: Pam S

0

Expert Reply:

The control knob on the Redarc Tow-Pro Liberty Brake Controller part # RED24FR is held in place with friction. The initial install of the control knob will need to be done with the dial set to 0 but if you mess up you can simply pull the knob off and retry. Removing the head a few times won't be an issue but if you do this persistently it could lead to a loss of friction and loose fit.

expert reply by: Conner L

0

Answer 1

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

view full answer...

Answer 2

Hey Andrew, I checked with Trailer Valet and the distance from the hitch pin hole to the ball center on the Trailer Valet adjustable ball mount part #TV26FR is 11.5 and 13 inches depending on which pin hole you use.

view full answer...

Answer 3

Hey Steve! Yes, the SnapPad StakPads are available in different colors. What color were you looking for? We have the following: -SnapPad StakPad Universal Leveling Block and Jack Pad for RVs and Trailers - Black - Qty 1 #SN74VR -SnapPad StakPad…

view full answer...

Answer 4

Hey Prajuk, congrats on the new camper! You have some awesome adventures in your future. As you mentioned, it's a relatively lightweight camper, topping out at around 3,500 when it's fully loaded. This is always a fun question to figure out…

view full answer...

Answer 5

For your 2024 Nissan Frontier I recommend the Redarc Tow-Pro Liberty Brake Controller #RED24FR. I like the Liberty because it is simple, reliable, and looks great in any vehicle. The main unit installs behind the dash, so only the control knob will…

view full answer...

Answer 6

Hey William! It looks like your 2025 Grand Design Imagine 2500RL has 4,400 lb overslung axles. Based on that information you need the following: -SumoSprings Trailer Helper Springs w/ Line Relocation Bracket - Single Axle - 3K to 5K - Overslung…

view full answer...

Answer 7

In regards to the Redarc Tow-Pro Liberty Brake Controller part ##RED24FR, the unit should not be illuminated while driving without a trailer. If you press the button while a trailer is not attached you should see a breathing blue light and that…

view full answer...

Answer 8

Since everything else is working on your Redarc Tow-Pro Liberty Brake Controller #RED24FR there may be a problem with the light pipe on the control knob. there is a 90 degree light pipe which is what brings the light up and out through the button. If…

view full answer...

Answer 9

In order to find out a jack for your Jayco, you're going to need to know what your trailer's tongue weight is and pick a jack that can support that weight rating. Since your Jayco has a GVWR of 3,950 lbs (and tongue weight is 10-15% of the…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

How To Remove Control Dial From Redarc Tow-Pro Liberty Brake Controller

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching