Replacement Window Edge Weather-strip/Glazing

Question

Question:

Looking for exterior window trim for a 2008 Safari Damara I doubt the picture is helpful

asked by: Cindy F

0

Expert Reply:

What you are needing is rubber window edging weather stripping for RVs, sometimes referred to as glazing. We have some options such as # SR43FR or # SR63FR. Please note the attached images. I suggest you pull the end of the current trim from window and look at the profile from the end, compare shape and measurements to what I have attached. Or feel free to take a measurement and picture then email to us for suggestions.

expert reply by: Michael R

0

Rubber Window Edge Weather Strip_001
(click to enlarge)

Rubber Window Edge Weather Strip_002
(click to enlarge)

0000001
(click to enlarge)

Answer 1

Hey Steven, we have the Performance Tool Windshield Locking Strip Tool #PT68VB that you could use as a tucking tool for the install of the Rubber Window Edge Weather Strip for RVs #SR66ZR that you referenced. Is this what you were looking for?

view full answer...

Answer 2

From the images you attached, description provided, etc. the Press In Window Edge Weatherstrip for Enclosed Trailer, #SR43FR that we offer is a similar product to what you have only in black. This will work as a replacement item if black is…

view full answer...

Answer 3

The most common window edge weather stripping, sometimes referred to as window glazing, for RV's is either #SR43FR at 1/2" x 1/4" or #SR63FR at 3/4" x 5/16". I suggest that you pull the end up on a section you currently have…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Replacement Window Edge Weather-strip/Glazing

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching