What Trailer Wiring Setup Do I Need for My 2022 Ford Explorer?

Question

Question:

What trailer wiring setup do I need for my 2022 Ford Explorer base model?

asked by: Kyle

0

Expert Reply:

As far as wiring for your 2022 Ford Explorer, if you need just brake lights/signal lights alone, you will only need the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118599. The T-One includes a ModuLite power converter to ensure that your vehicle's wiring matches that of your trailer. If you are looking to add a brake controller to the trailer, you will need the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat # ETBC7 in addition to the T-One.

To add a brake controller, I recommend the Tekonsha Voyager # 39510 or the Curt Echo # C51180. Both of these controllers are proportional controllers which means that the controller activates the trailer brakes in proportion to your vehicle's braking action. The Voyager is more of a traditional-style controller than requires mounting into the dashboard of your vehicle near the steering wheel. On the other hand, the Curt Echo allows you to control the settings of your controller with the ease of your Smart device.

If you need help installing any of these accessories, I went ahead and linked walk-through videos to guide you through the process.

expert reply by: Bob C

0

Answer 1

Hello Bruce, I can certainly try to point you in the right direction. Ford is notorious for making their brake control ports hard to find. On the 2023 Ford Explorer with the factory tow package, the connector is located under the dash on the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

What Trailer Wiring Setup Do I Need for My 2022 Ford Explorer?

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching