Replacement Air Lift Wireless Controller For First Generation Air Lift WirelessAir Compressor System

Question

Question:

I have the first generation Wireless model lost controller will this work

asked by: Chris G

0

Expert Reply:

For the first generation of the Air Lift WirelessAir compressor systems you will need the Replacement Wireless Remote AL73002.

The Replacement Remote Control # AL39NV will only work for the Air Lift WirelessONE Compressor System # AL25980 or # AL25980EZ

expert reply by: Bud M

0

Answer 1

Thank you for the images. Your harness was used on both the 1st generation WirelessOne and WirelessAir. The compressor and manifold are those used on the WirelessOne so you will need the Replacement Remote #AL72704.

view full answer...

Answer 2

Hey Joey, Air Lift transitioned from radio frequency to Bluetooth with their air compressors and no longer offers the older generation RF remotes. We no longer have any stock of this remote either so it'll probably be a hard find. Due to the…

view full answer...

Answer 3

That remote was unfortunately discontinued earlier this year (2023). Since it was this recent I recommend trying to locate one as opposed to finding a whole new system. You can try reaching out to Air Lift directly or look on a type of buy sell trade…

view full answer...

Answer 4

I found the remote that you will need for your Air Lift system. However, the #AL72704 that you referenced is the replacement remote for the WirelessOne system and not compatible. The replacement remote for the Air Lift WirelessAir Compressor System…

view full answer...

Answer 5

The correct replacement remote for the Wireless AIR 72000 that you referenced is the #AL73002 that you referenced.

view full answer...

Answer 6

For the first generation of the Air Lift WirelessAir compressor systems you will need the Replacement Wireless Remote #AL73002. You would not be able to use the second generation remote.

view full answer...

Answer 7

I reached out to AirLift and they told me when they run into this, they recommend doing a repairing procedure. Below is the steps they gave me to accomplish this: JOINING THE CONTROLLER TO THE MANIFOLD • Access the manifold. • Locate the YELLOW join…

view full answer...

Answer 8

I spoke to Air Lift to confirm and the Replacement Wireless Remote AL73002 will work as a replacement for your 73001 remote. You will need 3-AAA Batteries #287-11407 that are not included to power on the new remote. Once you place the batteries into…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Air Lift Wireless Controller For First Generation Air Lift WirelessAir Compressor System

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching