Overall Dimensions of Dutton Lainson Winch # DL14730

Question

Question:

What is the size of the winch base?

asked by: David N

0

Expert Reply:

The overall base width of the Dutton Lainson Winch # DL14730 that you referenced is 4-3/4 inches. The height from the bottom of the base to the top of the drum is 6-53/64 inches. And the length front to back is 6-1/4 inches, or 8-27/32 inches including the drum.

expert reply by: Jameson C

0

James G.

1/3/2025

I would like to put a U-Clamp around the long end of the brace. I’m mounting to a 2” metal aluminum tongue. Do the holes on the 4 3/4” width of the winch allow for that U-bolt?

Jameson C.

1/3/2025

@JamesG It sounds like you are asking if the the mounting base holes of the Dutton Lainson Winch # DL14730 could be used with a U-bolt to mount it and the answer to that is yes.

Answer 1

From what I have found, the Dutton-Lainson Hand Winch - TUFFPLATE Finish - Single Speed - 1,800 lbs #DL14627 will match the bolt pattern of your Shelby 5407B. I have attached a diagram as well as the dimensional drawing showing the bolt pattern on…

view full answer...

Answer 2

I went out to our warehouse so I could take some measurements on the Dutton-Lainson Hand Winch #DL14825 that you referenced. The main body of the winch measures 7 inches long, 5 inches tall, and 4-7/8 inches wide. With the wheel its length is 9-1/2…

view full answer...

Answer 3

The closest I can come to the same mounting holes you have for your DL1402A winch is part #DL14527. This is a 1,600-lb pulling winch and it has very similar mounting hole locations. I have attached dimensional drawings for the DL1402A and the…

view full answer...

Answer 4

In order to suggest the correct replacement winch, you'll need to pick a winch with a capacity at least half (or more) of the weight of the boat. Choosing a winch is one of those times when you'll want to use a little overkilll as far as the…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Overall Dimensions of Dutton Lainson Winch # DL14730

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching