bing tracking image
Customer Service My Orders
  1. Home
  2. Help Videos And Articles
  3. Trailer Hubs and Drums Help Hub
  4. Trailer Hubs and Drums Q&As
  5. Question 565701
Q & A Icon

Replacement Hub with 5 on 5 Bolt Pattern Using LM67048 and LM11949 Bearings  

Published 09/15/2021



Question:

Howdy! I have an order trailer. Probably homemade. It has a hub that is 5 on 5. The outer bearing is no. LM11949 or .750 and the inner is no. LM67048 or 1.25. Can you point me in the right direction to the correct hub? Thanks

0

Expert Reply:

I may have a solution for you to replace the bearings, but I'm not aware of a hub that uses these particular bearings and also has a 5 on 5 bolt pattern. Typically this bearing combination is found on smaller agricultural hubs.

Assuming your hubs are otherwise still in good working order you could simply swap in new bearings, races and grease seals. If you wanted to go that route then you'll need bearing # LM67048 with a race # LM67010 which have an inner diameter of 1.250 inches; then you can use the bearing # LM11949 with race # LM11910 which have an inner diameter of .750 inches.

If you can also provide the dimensions or a part number from your grease seal, I can try to locate a replacement seal for that as well.

expert reply by:
0
Erik B

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>