Replacement Stabilizer Jack for RV Lippert 113407

Question

Question:

Hi does the lc298707 cross with my part LCI model # 113407?

asked by: Scott T

0

Expert Reply:

The part # LC298707 is the current version of the stabilizer jack 113407 that you mentioned. Basically it's an updated version of the same setup.

expert reply by: Jameson C

0

Answer 1

I do have a solution for you, however the replacement legs for your Lippert model 113407 stabilizer jack are no longer available. Because of this you will need to replace the entire unit. For a direct replacement that will work well I recommend the…

view full answer...

Answer 2

Lippert does not offer just the replacement legs of their leveling/stabilizer jacks like the part #LC298707 that you referenced. This means you'd need to replace the entire thing.

view full answer...

Answer 3

Yes, the Lippert Electric Stabilizer Jack 113407 can be replaced with the Lippert High-Speed Power Stabilizer Jack part #LC298707. It will be a direct bolt-on swap, just simply cut and reattach the new wires and you'll be ready for use.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Replacement Stabilizer Jack for RV Lippert 113407

Continue Researching