Replacment Slide-Out Motor For Power Gear 522176

Question

Question:

Looking to replace a Powergear slide out motor, PN 522176W for a 2003 Country Coach Allure. From research, it appears this part may have been changed to a new part number Powergear 523983 or Lippert 383745. Any tips? Thanks!

asked by: Jessica S

0

Expert Reply:

From what I was able to find, the Power Gear 522176 was actually the direct replacement for the Power Gear 523983.

What I can confirm is that the Lippert 383745 you mentioned is the same motor (just with a different part number) as the 522176, and we do have the Lippert motor:

- Replacement Slide-Out Motor Assembly - Double Shaft # LC383745

expert reply by: Kyle S

0

Answer 1

We have just what you need to replace your landing gear motor M9000PK with the #LC196308 and you'd be set! This is a confirmed fit for what you have and is a faster motor too so your jacks will raise and lower quicker.

view full answer...

Answer 2

To replace your existing Venture motor, the Lippert Components Venture 5th Wheel RV Landing Gear Motor #LC142178 is the correct replacement part for you. For an aluminum gear box, you are correct that you can use part #LG-179015. The #LC142178 motor…

view full answer...

Answer 3

The correct replacement for your Power Gear 522176 is #LC383745. You can see current pricing by looking at the linked product description page.

view full answer...

Answer 4

Hey Steve, we have exactly what you are looking for. To replace your 510116 power gear controller you will need the following parts: - Replacement Sensing Control Panel for Power Gear Single Rail Above Floor Sofa Slide-Out #LC27WJ - Replacement…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hey Jairo. So we do not offer a direct replacement for the Norcold N611, but we do have a good replacement option for you. It really comes down to what will fit in your cutout space. Take a look at the Norcold RV Refrigerator w/ Freezer - 8.2 cu ft -…

view full answer...

Replacment Slide-Out Motor For Power Gear 522176

Product Page this Question was Asked From

Continue Researching