Does the CE Smith 60 Inch Long Post Style Guide-On Come in White

Question

Question:

do you have this item in white

asked by: Robert E

0

Expert Reply:

It looks like you might be looking for the CE Smith Post-Style Guide-Ons for Boat Trailers - 60" Long - I-Beam Clamps - White - Qty 2 # CE27648, which are a 60" post style guide on that are white in color.

expert reply by: Erik B

0

Answer 1

I went out into our warehouse to grab a part #CE27608PG and found that the other dimension you are looking for is 17 inches.

view full answer...

Answer 2

There is an upright which may work for you, the Replacement Upright for CE Smith Bunk-Style Guide-Ons for Boat Trailers - Lanced - 39" #CE27605PG. This upright has a bottom leg of 23 inches, and is a replacement for CE Smith Post-Style Guide-Ons…

view full answer...

Answer 3

The short leg of the CE Smith #CE27648 Post-Style Guide-Ons measures 21-1/2 inches from the end of the leg to the inside edge of the upright and 23 inches to the outside of the upright. I've shown these dimensions in the provided photo. CE Smith…

view full answer...

Answer 4

The 60" Long CE Smith Post-Style Guide-Ons for Boat Trailers #CE27648 are designed to be installed on I-Beam frames just like you noted in the review video (attached). Some of the review photos you're seeing are from other CE Smith guide-ons…

view full answer...

Answer 5

The best size guide on to get would be the one that works based on where you would attach them to your frame and the height of the boat. Ultimately that is up to you to decide. We have the #CE27620 which are 40" tall and also the 60" tall…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...