Do I Need A Support Jack To Replace A Gearbox For My 5th Wheel Trailer
Updated 08/02/2021 | Published 07/31/2021
Question:
Do you need to place a support jack under trailer before you remove gearbox ? My tube on the gear side did not retract the same amount as the non gearbox side. I suspect gearbox may need replaced.
asked by: Ray L
Helpful Expert Reply:
If you can level your trailer it is not necessary to add an additional support jack before removing your gearbox. The gearbox turns the screw that activates the jack, but it also has a fail safe that does not allow the jack to drop if the gearbox is removed. In the case you are not able to level your trailer, you will need an additional support jack.
I have included links to our stabilizer jacks and gear boxes below.
Product Page this Question was Asked From
Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gearbox
- Stromberg Carlson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor
- Q&A: Replacement Motor for a 125340 Motor Model Number 1a065012-02-01
- Q&A: Replacement Heavy Duty Motor For Landing Gear On 2010 Keystone Raptor Toy Hauler
- Q&A: Replacing ADTH 1RV-200 Landing Gear Motor
- Q&A: 5th Wheel Landing Gear Motor Comparison for Part Number From LCI 142178
- Q&A: Replacement Landing Gearbox for 125340 Motor on a 2008 Montana Mountaineer 35 foot 5th Wheel
- Q&A: Replacement Gear Box for Atwood 5th Wheel Landing Gear with a 75721 Motor
- Article: Brake Controller Installation: Starting from Scratch
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Best Landing Gear
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure a Trailer Axle