Do the Roadmaster Replacement Bushings Need to be Pressed In for the Install?
Updated 08/02/2021 | Published 07/31/2021
Question:
Do the bushing have to be pressed in? I have a 1999 fleerwood bounder motorhome
asked by: Debbie
0
Expert Reply:
Some of the bushings on the Roadmaster # RM-4139-125 will need to be pressed in, but it is not overly difficult. I included an install video we have of a similar Roadmaster kit that will show how this needs to be done.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
Roadmaster Polyurethane Bushing Kit for 1-1/2" Diameter, Factory Rear Anti-Sway Bar
- Anti-Sway Bars
- Anti-Sway Bar Bushings
- Rear
- 1-1/2 Inch Diameter
- Roadmaster
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Replacement Roadmaster Polyurethane Bushing Kit doI Need for My Itasca Suncruiser 32v V10?
- Shop: Roadmaster Polyurethane Bushing Kit for 1-1/2" Diameter, Factory Rear Anti-Sway Bar
- Video: Roadmaster Rear Anti-Sway Bar Polyurethane Bushing Kit Review
- Video: Best 1996 Ford F-53 Sway Bar Options
- Q&A: Replacement Anti-Sway Bar Bushings for Motorhome On Ford F-53 Chassis
- Q&A: Rear Factory Anti-Sway Bar Bushing Upgrade for 1999 Fleetwood Bounder 34v on Ford F53 Chassis
- Q&A: What is the Rear Sway Bar Size of a 2002 Ford F-53
- Q&A: Replacement For Roadmaster B451 End Link
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: How to Stop Leg From Spinning Installing Replacement Foot Pad for Lippert Hydraulic Ground Control
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams