Is Part # 9 of Replacement Gearbox Cover for Fulton F2 Swing-Up Jacks # F500135 Available Separately

Question

Question:

Is part 9 On your exploded view for the tongue jack is that available

asked by: Kent R

0

Expert Reply:

The gearbox (Part #9 on attached diagram) for Fulton F2 Swing-Up Jacks is not sold separately. This has been been confirmed by Fulton.

If you need to replace your jack, we have many available options including the Fulton F2 Swing-Up Trailer Jack # F1413040134.

expert reply by: Thomas M

0

Fulton Jack Parts Diagrm
(click to enlarge)

Answer 1

Hi George; there are some replacement parts available for the Fulton F2 Boat Trailer Jack #F1413020134. We have the following: -Replacement Handle and Crank Kit for Fulton F2 Swing-Up Jacks #F500134 -Replacement Pull Pin Kit for Fulton F2 Swing-Up…

view full answer...

Answer 2

I wasn't able to get exact info on your part number, but from the part number we know it's right hand thread wheel bolt like the part #RG02-020 which is a fine thread 1/2 inch diameter bolt with a 60 degree angled head. The other most likely…

view full answer...

Answer 3

Hey Robert, so the big difference between the two jacks is the frame dimensions they are designed to fit. The part #F1413040134 is for 3 inch by 4 inch whereas the #F1413140334 can fit frames that are up to 5 inches tall so it really comes down to…

view full answer...

Answer 4

For replacement parts for your F2, we have a pull pin #F500136, handle #F500134, and gear cover #F500135. We no longer have gears or bushings for the F2, You may need an entire new jack.

view full answer...

Answer 5

No, Sheldon I am sorry we do not. Additionally, I checked with Fulton and they do not offer what is labeled part number 9 on the exploded diagram listed below. If you need to replace this part you will most likely have to purchase a new Fulton F2…

view full answer...

Answer 6

I can definitely understand your frustration as the Fulton F2 Swing-Up Trailer Jack with Dual 7" Wheels, Sidewind -1,600 lbs F1413100334 is not a cheap jack so it would be nice to replace the plastic housing part number 9 in the included diagram…

view full answer...

Answer 7

For your Fulton F2 Swing-Up Trailer Jack, Dual 7" Wheels, Sidewind, Bolt-On - 1,600 lbs #F1413020134 part number 9 you referenced is not a replacement option. The outer tube components are not replaceable according to my contact at Fulton. That…

view full answer...

Answer 8

I spoke to my contact at Fulton and he said the correct replacement spring for the ratchet of your Fulton F2 winch is the part #4769-28. I attached a picture that shows a diagram for the winch for you to check out. You will be able to see how the…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Is Part # 9 of Replacement Gearbox Cover for Fulton F2 Swing-Up Jacks # F500135 Available Separately

Featured Help Information

Miscellaneous Media

Continue Researching