Fishwire and Reverse Fishwire Technique for Trailer Hitch Installation on a 2013 Subaru Crosstrek

Updated 04/12/2013 | Published 04/10/2013

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(401)

$188.94

etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs

(1382)

$95.20

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(3576)

$40.39

Question:

What is meant by reverse fishline the 1/2inch bolt into the frame?

asked by: Don H

Expert Reply:

Fishwiring is when you run a bolt leader, which is a long wire that on one end you can thread a bolt (it looks like spring), through the hole the bolt needs to go in, and out through a larger access hole. You then put on a spacer block or washer, then thread on the bolt and pull them back through the first hole.

Reverse fishwiring is when you put on the spacer block or washer, thread on the bolt, then shove them into the same hole they will need to come out of. Then you pull the fishwire back out so the bolt and washer or spacer seat properly.

I have included a video showing fishwiring and an FAQ with a section on fishwiring for you.

If you plan on doing some towing I recommend the etrailer ball mount kit # 989900 which comes with 2 ball mounts, 2 balls, a hitch pin with clip, and a storage bag. For trailer wiring use # C56040.

expert reply by: Michael H