Replacement Landing Gear Legs for RV that are 29-1/2 inch Measured Outer Tubes

Question

Question:

I measure 29 and 1/2 on the existing black part on the 2004 Sprinter 5th wheel I have -

asked by: Mary R

0

Expert Reply:

We do have the correct 29-1/2 inch replacement legs for Venture landing gear that is measured on the outer tube like you mentioned, which is the following:

- Replacement Lead Jack with Drop Leg # LG-179013

- Replacement Follow Jack with Drop Leg # LG-179014

expert reply by: Jameson C

0

Answer 1

Hey Mayra, thanks for the information and the picture. The Replacement #921 Lamp Bulb item #VA0415-00 would indeed replace your Hengs Range Hood Model RO624500C lamp. However, I have a better option for you. I recommend the 921/906 LED Light Bulb…

view full answer...

Answer 2

Hello Jean-Marc; to connect the third brake light you can use the 3rd Brake Light Logic Module #PP20-702. You will tap into the left and right brake/turn signal wires and run that up to your third brake light. The module will filter out the turn…

view full answer...

Answer 3

If you have measured your landing gear like in the accompanying diagram and the frame clamps are 18-1/2 inches apart you have an uncommon spacing; you can use the Landing Gear Set #LG-183708 but would need to have a welder come in and remove your…

view full answer...

Answer 4

Based on what your VMC900L has wrong with it the best option would be to replace the lead leg with part #LC119102.

view full answer...

Answer 5

For your 2018 Jayco 5th wheel 29bhds, determining the weld stop locations will help you determine the correct replacement lead leg for your trailer. For instance the typical weld stops are 17-1/2 inches from outside to outside like you find in the…

view full answer...

Answer 6

The Venture VMC900R is a very common landing gear set so for replacement legs we know you need the part #LC119102 for the lead leg and #LC119101 for the follow leg. Since you are wanting to fix the issue as cost effective as possible I would…

view full answer...

Answer 7

You have a few choices for replacement landing gear with legs that measure 29-1/2 inches, depending on what weight capacity you need and if you want manual or electric landing gear. - Stromberg Carlson #LG-1: Electric Landing Gear with 5,500 lb…

view full answer...

Replacement Landing Gear Legs for RV that are 29-1/2 inch Measured Outer Tubes

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching