Can I Use the Die-Cast Grate for Furrion Range on a Dometic CU-423 Range

Question

Question:

Hello, I read in your reviews that customers love this part to replace the wire grates in Airstream travel trailers. The Dometic stove top many of them reference is CU434. Our 2021 Classic Airstream has a Dometic CU423. Do you think this will be an appropriate fit for this model? Thank You

asked by: Sheila Z

1

Helpful Expert Reply:

We don't carry Dometic ranges and ovens, so I can't confirm this, but I do believe the CU-434 you've referenced is actually the range/oven combo that uses the same cooktop/range piece as part CU-423. Because of this, based off what some of our neighbors are saying the Furrion # CFSRE21SA002 is a good fit for your CU-423. We have not tested this ourselves though.

expert reply by: Erik B

1

Answer 1

Hey Allan. We've heard about this upgrade as well from quite a few customers but we do not have any Dometic ovens to confirm it on. What I can do is give you the dimensions for the Die-Cast Grate for Furrion Range Cooktop item #CFSRE21SA002.…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Can I Use the Die-Cast Grate for Furrion Range on a Dometic CU-423 Range

Product Page this Question was Asked From

Continue Researching