What Would Cause Water Intrusion on Oil Bath Hubs  

There are differences in them but we do have what you are looking for and they can in some situations be used together. The Replacement Trailer Hub Bearing you have part #02475 and Replacement Race for 02475 Bearing part #02420 are designed to work…

If you are wondering how to lubricate the Bulldog Square Jack #BD182701, that you referenced, then you will simply need to fill it with grease via the grease fittings. If you are referring to an oil bath on your hubs, like the Kodiak XL ProLube Kit…

The EZ Lube spindle style with the grease zerk is designed for maintaining your bearings and not for the initial grease of your bearings. The best way to pack your bearings with grease is to us the Powerbuilt Deluxe Bearing Packer #ALL647646. You…

You just need to pack the bearings on hub and drum assembly #8-276-5. There's no such thing as too much grease for bearings! If it is an EZ lube hub with a grease zerk fitting at the end of the spindle you will know there is enough grease once it…

You can install the Kodiak XL ProLube Kit for 3500-lb Axles #XLPROLUBE1980KIT if you have a 1.72" spindle, the kit does include a pair of oil bath caps for 1.98" hub bores. To install the kit you are going to need to remove your current…

It sounds like you may be pumping too much grease into your hubs and that is causing the seal to fail and leak grease out of the hub. You may have blown the seal already, but if not I would recommend trying a smaller amount of grease in the hub and…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

If you already have brake drums you will not have to replace them unless they are damaged or became overheated and have discoloration on the inside armature surface where the magnet rides, grooves in the armature surface, or severe wear where the…

We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage…