Search: oil bath hubs   >  

Thanks for the pictures! Since your UFP Gold Series oil bath hubs have a 1.98" outer bore then yes, the Kodiak XL ProLube Oil Bath Hub Body and Cap item #xlprolube1980 would work for your boat trailer. The directions say to fill to…

It sounds like you've got the Replacement Step, Motor, and Control for Kwikee RV Electric Steps - Platinum Series #LC372558-which corresponds to the part number you provided - 9010000220. The replacement motor for this Kwikee step is listed below…

The model number for fans such as the MaxxAir MaxxFan Mini Roof Vent, #MA00-04401M is listed on the upper side of the assembly itself. Please see the attached image. You will best identify this by opening the vent and climbing on top of the RV.…

I would be happy to help you! The EZ loader oil bath hub assembly 300-029534 is a complete 5-on-4-1/2 idler hub kit that includes races, bearings, seal, washers, nut, retainer nut and cotter pin, bearing protector and lug nuts. Some of these hubs fit…

I reached out to the manufacturer and was able to confirm the correct replacement for the Power Gear Slide-Out Controller 1510000013 is the Lippert Slide-Out Controller part #LC38TF.

I reached out to the manufacturer and was able to confirm the correct replacement for the Power Gear Slide-Out Controller 1510000013 is the Lippert Slide-Out Controller part #LC38TF.

We don't have the UFP Brand, but I can give you some compatible parts. For your trailer hubs with rotor, I recommend the Kodiak 10" Hub-and-Rotor Assembly - 5 on 4-1/2 - Dacromet - 3,500 lbs #KHR10D. You will need grease seal #RG06-050 along…

Yes, it will. The Roadmaster Battery Disconnect with Switch for Towed Vehicle w/ Flat Tow Brake System item #RM-766 is not only compatible with your 2024 Buick Encore GX but it is recommended to be used by Roadmaster. This a great part that makes…

According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…

The Replacement Lippert Leveling Control Brain #LC53ED is the replacement for the 10540 controller. If you are needing the Control Panel #LC175225 we also have that available. The Harness #LC178278 is needed to convert the 4-pin square connector on…

The modern equivalent of the H78-15 tires are tires sized at 225/75-15. A good replacement for your tire in this size is the Kenda Karrier 225/75-15 Radial Tire, part #AM10251. This tire has Load Range of C and is a 6 ply (the lowest we have in this…

You'll basically just need to remove as much of the oil from your hubs as you can and then pack them with grease instead of oil. Oil seals and caps seal better than grease seals and caps so to make the conversion you want to make is not hard at…