What is TorkLift Camper Packer Camper Stand Kit # TLA7010 Weight Capacity

Question

Question:

Hello, I saw this kit and I noticed it only states for storage. I wanted to know could it be used for sleeping in as well. When i pull my truck camper off I do like to not have to it all the way to the ground to sleep in it or stay a week at a park. Would this kit with the proper lumber be good for support/ enough to sleep in? Thanks!

asked by: Christopher H

0

Expert Reply:

When the TorkLift Camper Packer Camper Stand Kit # TLA7010 is assembled it has a capacity of 6,000 lbs so as long as your camper weighs less than that there's no reason you couldn't stay in it.

expert reply by: Jameson C

0

Answer 1

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 2

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 3

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 4

Hi Larry! We actually have two options that will fit your 2017 Ford F-450 with a Stromberg Carlson 4000 Series 5th Wheel Louvered Tailgate (like the #VG-15-4000) installed. I have both linked below: Brandmotion Tailgate Delete Backup Camera with…

view full answer...

Answer 5

Hello again Steven. The Camper Packer #TLA7010 is meant to support the camper under the main floor/frame structure, not out at the edges. You’ll use 2 stands, one toward the front and one toward the rear. We don’t have a specific placement for a…

view full answer...

Answer 6

Hi Steven; if you install the TorkLift SuperHitch Magnum #TLF1008-30 you will need different rear tie-downs for your F-450. The TorkLift Camper Tie-Downs #TLR3504 will replace what you have now. If you switch to a different aftermarket hitch you will…

view full answer...

Answer 7

Hello Ben, Thanks for writing in! Yes! The WeatherTech Front Auto Floor Mats #WT54TZ you were looking at are made specifically for the factory vinyl floor in your 2026 Ram 2500. For the rear, WeatherTech does not have a matching custom-fit rear mat…

view full answer...

Answer 8

Hey Duane, welcome back! The TorkLift SuperTruss Hitch Extension #TLE1532 has an overall length of 32". This is measured from the end of the SuperHitch receiver to end of SuperTruss receiver. What are you towing with your Silverado?

view full answer...

Answer 9

For your Lance 855s Camper with standard tracks I recommend the Rhino-Rack Quick Mount Legs for Vortex Aero Crossbars - RTC and RT Roof Rack Tracks - Qty 4 #RRRLT600 and then crossbars like the Rhino-Rack Vortex Aero Crossbars - Aluminum - Black -…

view full answer...

Answer 10

Thanks for reaching out again, Kevin! You'll need to go with the TorkLift SuperHitch Magnum Trailer Hitch Receiver #TL27CR for your 2024 Ford F-350 (which requires the removal of the factory hitch receiver if present), and then for the extender…

view full answer...

Answer 11

Brake controllers are designed to apply the brakes of a trailer in a smooth way that allows the towing vehicle and trailer to stop as efficiently as possible while minimizing wear on the braking components on the trailer and truck. A proportional…

view full answer...

What is TorkLift Camper Packer Camper Stand Kit # TLA7010 Weight Capacity

Product Page this Question was Asked From

Continue Researching