Need a Replacement Grease Seal with 1.50 ID and 2.565 OD

Updated 03/19/2013 | Published 03/14/2013

Question:

Im looking for a grease seal that has a 1.40-1.50 ID and a 2.565 OD. Do you have something like that?

asked by: Jason M

Expert Reply:

We do not have a grease seal with this particular combination of inner and outer diameters. We have seals with both inner diameters you provide, and seals with the same outer diameter, but not both.

If you took your measurements from the old seal, rather than the axle spindle and hub, it is possible that the seals are deformed slightly from wear which could make the measurements unreliable.

One option is to give us the inner and outer bearing numbers; from these we can find the corresponding grease seals.

The other option is to take measurements of the spindle and hub bore using a precision digital caliper. Obtaining the measurements in this way may result in different dimensions. Please take a look at the attached photo which shows where the spindle should be measured for the grease seal inner diameter. The hub bore measurement will provide the seal outer diameter.

expert reply by: Adam R