Recommended Replacement Handle For Older Fulton K1550 Brake Winch

Question

Question:

Will this handle fit bolt on, and work to turn my Fulton K1550? I am wasting a stupid amount of time trying to find an 11inch replacement handle that will work, so I figured I better ask someone. Original Part # I found listed was 2461S01, but it is nowhere in existence. Any help would be appreciated. Thank You

asked by: Leo D

0

Expert Reply:

I reached out to my contact at Fulton and confirmed that the Replacement 11" Long Winch Handle for Fulton Single-Speed Winches # F501101 you were looking at is the correct replacement for your older Fulton K1550.

I included a video of the # F501101 for you to take a look at.

expert reply by: Samuel C

0

Answer 1

As long as your winch is a Dutton Lainson B series winch, you can use the #DL6456 socket on it. The socket fits in 1/2" drill and measures 13/16" x 13/16" (outside). The number that you mentioned is just a number used to identify the…

view full answer...

Answer 2

Replacement Pinion Shaft for Fulton 1500 Series Winch #F501118 is the correct replacement for your drive shaft. The K1550 is part #F143100 and the shaft is shown in the attached photo where it connects to the handle. The boat lift wheel will attach…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Recommended Replacement Handle For Older Fulton K1550 Brake Winch

Featured Help Information

Miscellaneous Media

Continue Researching