Replacement Velcro Strips For Truxedo Lo Pro Tonneau Cover

Question

Question:

I have a 2012 dodge ram with a Tuxedo cover thatneeds replacement velcro strips. I am confused as which strips to order. The current strips are 1 inch wide and 63 3/4 in long. Please let me know which strips tp order....thanks,

asked by: ROBERT S

0

Expert Reply:

Replacement TruXedo Shur-Bond Hook-And-Loop Fastener Strips # TX1117876 is the correct replacement velcro strip for your Tuxedo tonneau cover on your 2012 Dodge Ram. You will need to trim to size, as these strips are 1" wide and 80" long. Self-tapping screws are included for installation. I attached a demonstration video for you to check out.

expert reply by: Andrew N

0

Answer 1

We do have an option for you, however, we do not have a 1-5/16 wide by 8' long velcro replacement for your TruXedo tonneau cover What we do have is the Replacement Velcro Shur-Bond Fastener for TruXedo Deuce Tonneau Covers #TX1117785. This…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

From the center of the tube to the center of the tube for the Westin E-Series Round Nerf Bars #23-0500 is measures 48" but then the overall length is 51". Please note that this is designed to fit various models of Yukon, Tahoe, Blazer, and…

view full answer...

Answer 7

Yes if you used a self-tapping screw like the part #FA1131822 you could use it to ground trailer wiring to a frame. Sometimes aluminum trailer frames aren't quite adequate so you may need to run a jumper wire to the main ground wire of the…

view full answer...

Answer 8

The correct replacement for your Power Gear Slide-Out motor 521748 is the Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386322. I have added a link to a video review for you as well.

view full answer...

Answer 9

Hey Mitch! You can use the RV Propane Gas Detector - 12 Volt - 2 Wire - Black #RS44FR to replace your existing detector. However, you will need to remove the old detector and valve, then reconnect the line with the appropriate fitting. There isn’t a…

view full answer...

Replacement Velcro Strips For Truxedo Lo Pro Tonneau Cover

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching